#1: DIY Soundproofing to Your Car Insulflex® Heat and SoundProo Author: jh6162, Posted: Wed Mar 23, 2011 2:59 am ---- Salam & Hello,Wanted to sell as below item described :
DIY Soundproofing to Your Car
Item(s):Insulflex® Heat and SoundProofing Material(non adhesive @ no backside glue/gam)
SUITABLE for all cars.
Recommended to use on :
1. Doors
2. Front bonnet
3. Rear trunk lid
4. Boot floor and walls
5. Floor pan
6. Front fender / wheel arc
7. Roof
8. Engine firewall
Facts:
1 -Great for a quiet and comfortable
Sound Rated at : NRC 0.14
2 - Lightweight material
3 - Low water absorption rate(waterproof)
4 - Fireproof
Data from INSULFLEX:
5 - The above average physical properties are values obtained in accordance with accepted test methods.
6 - At -40°C, Insulflex Closed Cell Insulation becomes hard and as temperature drops below -40°C will be increasingly brittle; however this hardening chracteristic does not affect thermal or water vapour permeability.
7 - The Fire rating standard method of tests conducted under controlled laboratory conditions is a measure of a material to spread flame when compared to a known standard and is not intended to reflect hazards presented by this or any material under actual fire conditions.
Price: RM40 Per Sheet Standard Sheet Sizes: 3ft x 4.3ft
Thickness : Available in 6mm & 10mm
COD at Taman TTDI Jaya & Shah Alam Area
Postage can be arrange
Note :
*Minimum Order For Postage is 3 Sheet(9ft)
*Postage cost is paid by buyer
*Postage is through Pos Malaysia E-Parcel,will be delivered within 1 week after payment is confirmed
Please CALL
NO SMS
Khairul
0179705607
Additional Info :
Dunlop GP Adhesive/Dunlop CA Adhesive can be used as adheshive as it just rm10-20 per can..combine all cost,it's a cheap DIY..
